NORAC UC5-BC-CBL - Manual (Page 8)

5
4 Choosing the Correct Cables
The following table shows the cables that are required for the main connections in the UC5
system. Refer to Figure 4 for the location of each cable by item number.
Item
Part
Number
Description
Available
Lengths
Typical
Length
Quantity
Needed
C01 43220-XX
Control Module to Valve Module:
UC5 Network Cable 14 AWG 0.5,1,3,5,7,10,
15,20 m
10 m 1
C02 43220-XX
Valve Module to Input Module:
UC5 Network Cable 14 AWG 0.5,1,3,5,7,10,
15,20 m
1 m 1
C03 43220-XX
Input Module to 8-way Coupler:
UC5 Network Cable 14 AWG 0.5,1,3,5,7,10,
15,20 m
1 m 1
C04 43220-XX
Main Lift Sensor to 8-way Coupler:
UC5 Network Cable 14 AWG
(This cable is not always required)
0.5,1,3,5,7,10,
15,20 m
3 m 1
C05 43210-XX
Wing Sensor to 8-way Coupler:
UC5 Network Cable 18 AWG
10,15,20 m 20 m 2
C10 Various UC5 Valve Cable 0.18,0.9,1.8 m 0.18 m 4
C20 Various UC5 Tilt Interface Cable Various 1.5 m 1
C21 Various UC5 Main Lift, Bypass & Slant Interface Cable Various 1.5 m 1
C30 Various UC5 Battery Cable Various 1.5 m 1