NORAC 54VT-GS2-SP02 - Manual (Page 6)

4
3 Installation
3.1 CANbus Interface Installation
1. Securely mount the control module (E01) inside the sprayer cab.
2. Tee the CANbus interface cable (C40) in to the John Deere CANbus. The John Deere
CANbus connection can be found in the right hand armrest. To access this connector,
remove the three (3) screws from the bottom of the armrest, the bolt and nut securing the
hydro cable and the two (2) screws from the top hinged cover (Figure 2). The connector is
a 4 pin Deutsch plug labeled “CAN 2”.
3. Connect the 6 pin Deutsch plug on cable C40 to the 2-way coupler (E12). Connect cable
C41 between the 2-way coupler (E12) and the end of the control module with only one
Deutsch connector. C41 and E12 may not be required.
Figure 1: CANbus Interface Installation
Figure 2: A – Screw Locations on Underside of Armrest; B – Screw Locations inside Armrest;
C – Armrest Removal
A B C