NORAC PULSE-SP01 - Manual (Page 6)

4
3 Installation
Ensure the PULSE power switch is OFF for the remainder of the installation
(Bottom of switch pressed IN).
1. Install the PULSE™ display in the cab of the sprayer where it will be clearly visible and
within easy reach of the operator.
2. RAM manufactures a suction cup mount that works well for installing the PULSE display.
The suction cup mount is not supplied with this kit, but is available from NORAC or RAM.
See Section 1.2 for ordering information.
3. Connect the cable from the PULSE display (D01) to one of the couplers (E20) and connect
one of the network cables (C01) to the other side of the coupler. Connect the remaining
coupler (E20) between the two network cables (C01).
4. Connect the free end of the second network cable (C01) to the Display Bus connector on
the control module (E01). This is the end of the control module that only has one Deutsch
connector.
Figure 1: PULSE Display Kit Parts