NORAC UC5-BC-VS01 - Manual (Page 24)

21
8.3 Input Module
1. Install the input module (E03) on the boom near the sprayer valve block. Secure it to the
boom using cable ties or optional brackets.
2. Connect the free end of the CANbus cable (C02) from the valve module to the input
module.
3. Insert the 12 pin plug (P02) into the OEM 3 connector on the end of the input module
4. Connect the 12 pin connector on the tilt interface cable (C20) to the Thru 2 connector on
the side of the input module.
5. Insert the tee labeled Left Down into the Versatile valve connection labeled #2. Insert the
tee labeled Right Down into the Versatile valve connection labeled #3. Insert the tee labeled
Left Up into the Versatile valve connection labeled #12. Insert the tee labeled Right Up into
the Versatile valve connection labeled #13.
Figure 23: Input Module Connections
6. Connect the 12 pin connector on the main lift interface cable (C21) to the Thru 1
connector on the side of the input module.
7. Insert the tee labeled Main Down into the Versatile valve connection labeled #1. Insert the
tee labeled Main Up into the Versatile valve connection labeled #11.
8. Connect the male and female connectors marked AUX 1 together and the male and female
connectors marked AUX 2 together.