NORAC UC5-BC-JD08 - Manual (Page 26)

23
6. Route the long cable (with Deutsch connectors) on C21 under the sprayer. Connect the
tee connectors into the jam valve connector, located at the JD shuttle valve, under the
sprayer (Figure 24).
Figure 24: Load Sense Jam Valve Connector
There is one set of different connectors included with the tilt interface cable.
Some John Deere sprayers use this connector on the left down function. If
thesprayer has this connector, remove the existing connectors using the included
pin removal tool. Insert the wires into the new connector and ensure they are in
the same position as they were in the previous connector.
Insert tee
connector
here