NORAC UC4.5-BC-EV5 Part 2 - Manual (Page 5)

2
3 Control Panel Installation
Install the UC4.5 Control Panel (E01) in the cab of the sprayer with the supplied mounting
bracket. The location must facilitate connecting the power cable (C10) to the back of the
UC4.5 Control Panel.
4 Cable Installation
Figure 1: Cable Connections
1. Connect C10 to the UC4.5 Control Panel in the sprayer cab. Ensure that both connectors
(P16 and P4) are connected to the panel. Cable tie C10 to the RAM mount to help provide
strain relief.
2. Route the plug end (P12/P6) of C10 to the exterior of the cab and connect to C11 at the
hitch. Ensure cable is routed in a safe manner to avoid damage.
3. Connect C30 to P6A on C10 using E12. Connect C30 to an appropriate power supply.
4. All other cables and connections are factory installed.