NORAC UC4.5-BC-EV5 Part 1 - Manual (Page 14)

11
2. Insert C19 into the unused 6-way shroud on C11.
Figure 11: Opened Electronics Enclosure - J1 and J2 as indicated by arrows.
Function
NORAC UC4.5 EVRARD
Cable Color Connector Pin Wire
Bypass C13 Green J1 BYP Leave
Main Down C12 White J2 ED1 Leave
Main Up C12 Orange J2 ED2 Leave
Roll CCW C16 White J2 ED3 Leave
Roll CW C16 Black J2 ED4 Leave
Table 1: Interface Wiring for EVRARD Electronics
3. All connections “tee” into the terminal (which already have a wire connected).
4. Close the electronics enclosure.
5. Fasten the 3-way coupler to the boom with cable ties. Connect P6 on C11 to the 3-way
coupler.
6. Connect two cables (C05) to the 3-way coupler and route along the booms to the wing
sensors. Follow existing cables and hoses to be sure the cable will not be pinched or
stretched.
7. At the sensor brackets, attach a 2-way coupler with terminator (E20) to the sprayer boom.
The 2-way coupler with terminator is the white two way coupler. Plug the sensor and the
CANbus cable into the 2-way coupler.
IMPORTANT:
Provide enough slack in all cables to account for the movement of the main
section, parallel lift, and FOLDING boom movement.