National Cart SCS-2449 SIDEWALK CHALKBOARD DISPLY - Manual (Page 3)

*** For the latest product information go to www.nationalcart.com ***
Revision Date: Mar. 2013
All Safety-Warning Labels are
present and fully legible.
All moving parts can be operated
properly and with ease.
There are no missing or broken
components on the cart (bum-
pers, handles, etc.) and all
fasteners are tight and secure.
Wheels and casters are not bent,
loose or missing from their
mountings and the wheels roll
freely.
There are no bent, cracked sharp,
or protruding areas on the cart
that may cause injury.
All welds and/or joints are intact
and the cart is level to the ground.
Safety Inspection Criteria
Inspect your products as necessary to keep
them in proper working order. To aid you in
performing routine Safety Inspections; we are
providing the following Safety Inspection Check-
list. Products should be visually inspected regu-
larly to identify problems. Train associates to
know what to look for during inspections.
Remove products from service immediately
if any safety issues are found.
Safety Inspection Checklist
If one or more of the following criteria fails upon
inspection of a rolling stock product, – RE-
MOVE FROM SERVICE IMMEDIATELY UN-
TIL A REPAIR OR REPLACEMENT CAN BE
MADE. Items that have been removed from
the fleet for repair should be tied together with
a lock and chain and labeled “DO NOT USE –
UNSAFE” until they can be repaired or
replaced.
Maintenance
Recommendations
Your National Cart Products have been de-
signed to withstand the daily rigor of normal use
and to perform as expected throughout their
service life with minimal maintenance. While
special cases may exist, the care and mainte-
nance of the products is your responsibility. By
following the procedures listed below, you can
be sure that your purchase will have a long and
useful life. We strongly recommend that you
perform a thorough cleaning and routine main-
tenance every 3-6 months. The products should
be serviced by a trained in-house associate, or
a qualified service company.
CLEAN PRODUCTS EVERY 3
TO 6 MONTHS.
• Products exposed to snow, ice and salt will
need to be cleaned/maintained more often. This
is especially important in Northern Regions
• Take products outside and into a secured
corner of your parking lot, away from cars and
patrons when cleaning.
• When using a power washer do not exceed
1500 psi of water pressure or 150 degrees F. of
water temperature. Too much pressure or heat
can damage the finish.
• Remember to check with your local and state
regulations regarding runoff of detergents or
cleaners.
• Allow products to air-dry completely before
returning them to the store.
• Never use a solvent or a degreaser on the
bearings of your products. If the casters are
making excessive noise use a caster-manufac-
turer recommended oil or grease.