Milwaukee Tool 9682-20 V.1 - Manual (Page 9)

9
REEVING LOAD CHAIN
Installing a new length of load chain
To replace the load chain, remove the lower hook block and
chain stop from the chain. Move the directional lever to the
neutral “N” and pull the old chain out of the hoist. Feed a length
of soft wire through one side of the chain guide roller and over
the liftwheel until it comes out on the other side of the chain
guide roller.
Attach the wire to the end of the new chain. Position the chain
so that the first link to enter the chain guide roller will be an
upstanding link and the welds on all upstanding links will be
away from the liftwheel. Pull on the wire until the chain
engages the liftwheel. Turn the free chaining knob, while pulling
on the wire, until the chain comes out of the chain guide roller.
Pull the chain through and remove the wire. Attach the lower
hook block to the chain that is directly below the upper hook.
Attach the chain stop to the other end of the chain.
TESTING
Prior to initial use, all altered, repaired or used hoists that have
not been operated for the previous 12 months should be tested
by the user for proper operation. Test the unit without a load
and then with a load of 100 pounds (46 Kg) to be sure that the
hoist operates properly and that the brake holds the load when
the lever is released. Then test with a load of 125% of rated
capacity. Hoists in which load sustaining parts have been
replaced should be tested with a load of 125% of rated
capacity by, or under the direction of, an appointed person and
a written report prepared for record purposes.
Every MILWAUKEE product is warranted to be free from
defects in material and workmanship. MILWAUKEE will repair
or replace any product which examination proves to be
defective in material or workmanship.
Limitations: This warranty does not cover: 1) repairs made or
attempted by other than
MILWAUKEE or MILWAUKEE
Authorized Service Station personnel; 2) normal wear and tear;
3) abuse; 4) misuse; 5) improper maintenance; 6) continued
use after partial failure; 7) tools that have been modified; or
product used with an improper accessory.
Battery Packs are warranted for one (1) year from the date of
purchase.
Should a problem develop, return the complete product to any
MILWAUKEE Factory Service Center or MILWAUKEE
Authorized Service Station, freight prepaid and insured. If
inspection shows the problem is caused by a defect in material
or workmanship, all repairs or a replacement will be made at
no charge and the product will be returned, transportation
prepaid. No other warranty, written or verbal, is authorized.
THE REPAIR AND REPLACEMENT REMEDIES DESCRIBED
HEREIN ARE EXCLUSIVE. IN NO EVENT SHALL
MILWAUKEE BE LIABLE FOR ANY INCIDENTAL, SPECIAL,
OR CONSEQUENTIAL DAMAGES, INCLUDING LOSS OF
PROFITS.
THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES,
EXPRESSED OR IMPLIED WHETHER FOR
MERCHANTABILITY OR FITNESS FOR PARTICULAR USE
OR PURPOSE.
This warranty gives you specific legal rights. You may also
have other rights that vary from state to state. In those
states that do not allow the exclusion of implied
warranties or limitations of incidental or consequential
damages, the above limitations or exclusions may not
apply to you.
For a complete listing of accessories refer to your MILWAUKEE
Electric Tool catalog. To obtain a catalog, contact your local
distributor.
To reduce the risk of injury, use only specifically
recommended accessories. Others may be
hazardous.
Figure 8
Timing
Marks
Figure 9
Chain guide
roller-Lower
Hook Side
To reduce the risk of injury, feed load chain between
liftwheel and chain guide before attaching the
warning tubes and end ring. Failure to properly install
the load chain may cause the chain to lift out of the
liftwheel pockets and allow the load to drop.
Stripper
Lower
Hook
Block Chain Stop-
Position as
Shown
Chain Welds
Away From
Liftwheel
Liftwheel
Chain Guide
Roller-Chain
Stop Side
WARRANTY
ACCESSORIES