Coleman p9945-700 - Manual (Page 3)

3
Assembly
(cont)
HANDLE ASSEMBLY
■ Place Lid upside
down on a nonabra-
sive surface to
protect the finish and
attach as shown.
(Step 8)
Lid
H-2
H-3
H-1
Handle
LID ASSEMBLY
■ Place Lid on Base.
■ Align holes in Top Hinges
with holes in Bottom
Hinges then secure with
Bolt Hardware as shown.
(Step 8)
RIGHT LEG ASSEMBLY
■ Tap one L-7 onto Wheel Axle. (Step 4)
Wheel
Axle
L-6
Wheel
Axle
L-6
Wheel
A-1
Clip
NOTE: Clip orientation is important. See Detail 5b.
Clip
Clip
A-1
■ Align Right Leg with Bracket and repeat Steps 1, 2, and 3.
NOTE: After Right Leg is assembled the Leg should have slight
resistance in movement.
HH-1
HH-2
HH-3
Step 4
Step 5 Detail 5a
Right Leg Assembled
Step 7
Step 8
Step 9
Step 8
■ Install Axle and hardware as shown. (Step 5)
See Blister Pack for hardware identification.
Step 6
Be careful not to overtighten.
CHARCOAL GRATE ASSEMBLY
■ Place Charcoal Grate in Base and rotate allowing Lever to slide
through opening in Base as shown.
Step 8a
See Blister Pack for
hardware identification.
See Blister Pack for hardware identification.
See Blister Pack for
hardware identification.
Detail 5b
Lever