Mastersound Compact 300 B - Manual (Page 4)

- 7 -
Switching on of the amplifier
On the front panel of the monoblock there are illuminated
with a red led lights, which should go on when You switch on the
amplifier, indicating the correct functioning.
When the inner tensions have reached the correct level, while
the red led light grows bright, the Compact 300 B is ready to work.
Only after the amplifier be pre-heated for at least twenty
minutes, will it reach the ideal temperature so as to get the best
results in listening.
Last recommendations
Any change of interconnectors (cables, etc...) must be done
with the amplifier switched in the off position.
Never move or remove the amplifier when tubes are still hot.
Never install or remove tubes when the amplifier is still
switched in the on position.
- 8 -
Maintenance of the amplifier
Use gently a wet and soft cloth (buckskin) to clean Your
amplifier and dry immediately.
Never clean Your amplifier when hot or running.
Do not forget to take out the plugs before starting to clean the
amplifier.
The contents of the box
• 1 amplifiers
•
1 volume remote control
•
a complete set of select tubes
•
1 feed-line cables
•
the warranty
•
1 user’s handbook