Longshine LCS-8038TXR7 - Manual (Page 6)

2.3 Connect Fast Ethernet
Category 5 UTP cable is required for Fast Ethernet
operation. The maximum cable run between the adapter
and the supporting hub is 300ft (100m). Make the network
connection by plugging one end of the cable into the RJ-45
receptacle of the adapter, and the other end into one port in
the hub.
2.4 Connect 10Mbps Ethernet
Category 3, Category 4, and Category 5 UTP cable, as well
as EIA/TIA 568 100 ohm STP cable, all qualification under
Ethernet cabling rules. The maximum cable length run
between this adapter and the supporting hub is 300 ft. Make
the network connection by plugging one end of the cable
into the RJ-45 receptacle of this adapter, and the other end
into the hub.
E-6