Chariot Carriers CABRIOLET CTS - Manual (Page 6)

Insert the hitch arm by pressing the small but-
ton and sliding the arm into the wheel arm
attachment bracket. The large button should
engage into the hole on the wheel arm
attachment bracket.
Insert the securing pin down through the
small rear hole in the wheel arm attachment
bracket.
1.3 Hitch Arm Assembly for Cabriolet
1.1 Wheel Assembly (Caddie and
Cabriolet)
To insert wheel into axle, simply insert the
clevis axle attached to the wheel into the
end of the hollow axle. Once fully inserted,
you should hear a "click" sound. IMPORTANT: To ensure the axle system is
engaged properly, test by trying to pull the
wheel outwards after installing. The wheel
should be locked in its installed position. If
not, do not use and take your carrier to
your local dealer for servicing. To release the wheel from the axle, there is
a safety spring button which needs to be
released located on the axle pointed
towards the rear of the carrier. Pull this
spring button towards the rear of the carrier
and remove the wheel.
1.4 Hitch Arm Assembly for Caddie
Insert hitch arm straight into the ‘left’ hitch
arm attachment bracket.
When inserted properly the end cap on the
hitch arm should be seen from the back of
the hitch arm attachment bracket.
Insert safety snap pin up through the holes
in BOTH the hitch arm attachment bracket
and the hitch arm. Lock safety snap pin by
securing the clip over the pin.
WARNING: Failure to lock safety pin
could cause the carrier to separate from
the bicycle resulting in serious injury or
death.
5
1. Depress the rubber cap on the wheel hub with your thumb and fully insert the clevis axle into the hollow axle. Once fully inserted and
secured, you should hear a “click” sound. Important: To ensure the axle system is engaged properly, test by trying to pull the wheel outwards
after installing. The wheel should be locked in its installed position. If not, do not use and take your carrier to your Chariot Dealer for servicing.
2. Repeat all steps for the other wheel.
1.2 Wheel Assembly (Corsaire)