Levana Ayden - Manual (Page 6)

10 11
Pairing the Monitor and the Camera(s)
The camera and monitor come paired (connected) to each other automatically. However,
if upon opening this package the devices do not automatically connect and transmit, you
may do so manually.
To pair additional cameras, repeat steps below and be sure to assign a different camera
number to each additional camera.
SETUP
Note: Before you begin pairing, be sure to have the monitor and the camera(s)
side by side.
3 ft
away
Mounting the Camera on a Tabletop Safely
1. Place the Camera on a tabletop no less than 3 feet away from your baby’s crib.
2. Feed the power cord down the back of the table or use wall clips (not included) to
secure the cord away so the baby cannot reach it.
3. Plug in the power cord, check the monitor to ensure that you can see and hear
your child.
Note: Baby monitors with power cords should never be hung on or near the crib
as it is a strangulation hazard. Power cords should be kept no less than 3 feet
away from the crib and the baby’s reach at all times.
SETUP
Placement of the Monitor
You can place the monitor on a tabletop by using
the retractable table stand on the back of the
monitor. When not in use, simply tuck the table
stand away into the back of the monitor until you
hear a “click”.