Leapers COP 200 LED Light, Single Battery, Handheld or QD Mount (LT-EL138) - Manual (Page 5)

7 8
Replacement
Parts
Contact your
distributor for
information:
Lithium Battery Pressure Switch
1PC of CR123A
Lithium Battery
RG-FL138
UTG Offset Angled Low Profile
Tactical Flashlight Ring
Maintenance
1. Maintain the metal surface of the flashlight by removing any dirt or sand with a
soft brush to avoid scratching the finish.
2. Store the flashlight in a cool dry place when not in use. Be careful to avoid
contact with acid, alkaline or corrosive chemicals.
3. Replace the batteries in your flashlight every few months if it was not used
for long period of time. This insures good working batteries for your light and
prevents battery leakage.
4. Keep a fresh package of batteries next to your flashlight. This gives you
back-up power for your light.
5. Do not store your flashlight in high temperatures. This would damage your
flashlight and may result in battery leakage.
6. Do not put the flashlight head against any surface especially paper or human
skin for it has heat and may result in accidents.
7. Do not leave your flashlight under the seat in your car, or in direct sunlight to
avoid over-heating.
8. Do not attempt to lubricate any part of the flashlight.
9. Do not disassemble the flashlight other than replacing battery or pressure
switch. Do not loosen or remove screws or parts. Any such or similar actions
will void the warranty.