LABEC DW-FL270 - Manual (Page 2)

Ultra Low Temperature Freezer
Operation Manual
Models DW-FL90,DW-FL135 and DW-FL270
Thank you for buying a Labec ULT freezer.
For your personal safety and better performance of this unit, please read this Operation Manual
thoroughly and store it properly for future reference.
Failure to read, understand and follow the instructions in this manual may result in damage to
the unit, injury to operating personnel and poor equipment performance.
The material in this manual is for information purposes only. The contents and the product it
describes are subject to change without notice. Labec makes no representations or
warranties with respect to this manual.
Always use the proper protective equipment (clothing, gloves, goggles etc.).
Always dissipate extreme cold or heat and wear protective clothing.
Always follow good hygiene practices.
Each individual is responsible for his or her own safety.
Safety Notice:
Please read this manual carefully when using this unit for the first time.
The person who operates Ultra Low Temperature Freezer should be trained and authorized.
Any repairs of this unit should be carried out by Labec or their agent.
If you have questions which are not answered by the manual, please contact Labec or their
agent.
It is recommended that only Labec spare parts be used for repairs. Labec will not be held
responsible for any problems caused by using other manufacturers’ parts.
All routine check-ups and maintenance to Ultra low temperature freezer should be carried out
at the stated times.
Ultra Low temperature Freezers are NOT be used for storing live products which are not suited
to the low temperature.
Ultra Low temperature Freezers use a condenser to refrigerate. To ensure the freezer runs
efficiently, ventilation vents on the back and both sides of the unit must be kept away from the
wall at least 30cm and not be blocked by any barrier.
When Ultra Low temperature Freezer is working the chamber temperature is very low. This
may cause damage to bare skin, all protective equipment must be worn.
If the power shuts off, please wait 5 minutes before restarting to prevent compressor damage.