Kuzma STOGI S 12 VTA 130404 - Manual (Page 7)

7
4. Cueing device adjustment:
Should you find that in the ‘up’ position the cartridge is too high or too low above the record
then the cueing device can be raised or lowered. This can be done simply by using Allen key
1.5 mm:
Insert key into screw on side of arm rest.
Release screw, raise or lower device and retighten.
Rotation of cueing device can affect the drift of cartridge while traveling vertically down.
The cueing device may lift slightly as the screw is retightened. Do not over-tighten as this
may cause the cueing device to stick in the ‘up’ position. Should this occur, slightly release
the screw.
Tube rest:
The height of the tube rest can be adjusted with Allen key (1.5 mm).
5. Maintenance:
Bearing:
The bearing does not require any maintenance.
Cueing device:
Occasionally clean the black foam tube support to increase grip, using soft cloth soaked in
alcohol.
6. Problems:
Silicone oil spill:
If oil is spilled, firmly wipe with cloth or paper towel. Afterwards clean with a soft cloth
soaked in alcohol.
Tube running outwards:
Due to the silicone damping and descent rate of the tonearm, lower friction on the cueing
device in the 'play' position may cause the tube to travel towards the outer edge of the record.
Check that surfaces on the cueing device are clean and, with fingers, bend down the part of
the cueing device which lifts the tube at the inner groove. Check that bias is not too strong.
Also check that the wire loop is in a normal arc .
Mistracking:
Inadequate tracking force.
The cartridge may be too light. If so check the choice of counterweight and use only one
instead of two, or consult your dealer.
Cueing device too high in 'play' position and is touching the tube. See the air gap and lower
the cueing device.