Kuzma STOGI S 100909 - Manual (Page 9)

9
Mainentance:
Bearing:
The bearing does not require any maintenance.
Cueing device:
Occasionally clean the black foam tube support to increase grip, using soft cloth soaked in
alcohol.
Problems:
Silicone oil spill :
If oil is spilled, firmly wipe with cloth or paper towel. Afterwards clean with a soft cloth
soaked in alcohol.
Tube runing outwards:
Due to the silicone damping and descent rate of the tonearm, lower friction on the cueing
device in the 'play' position may cause the tube to travel towards the outer edge of the record.
Check that surfaces on the cueing device are clean and, with fingers, bend down the part of
the cueing device which lifts the tube at the inner groove. Check that bias is not too strong.
Also check that the wire loop is in a normal arc .
Mistracking:
Inadequate tracking force.
The cartridge may be too light. If so check the choice of counterweight and use only one
instead of two, or consult your dealer.
Cueing device too high in 'play' position and is touching the tube. See the air gap and lower
the cueing device.
Transportation:
When moved, be sure to secure the tube against the armrest and be sure that you do not tilt
the turntable for more than 15 degrees, as this could cause a leakage of silicone oil.
If moving longer distances, refix the cable to the back of the tube, lift up the tube base and
keep it above the bearing base for a short period of time until the silicone oil has dropped
back into the reservoir. Clean the brass damping base with a paper towel. If you cannot be
sure that the bearing base will be shipped level, remove silicone oil by pouring it away and
wipe surfaces with a paper tower. If necessary obtain a new bottle of silicone oil from your
dealer.
Kuzma Ltd
Hotemaze 17A
SI-4205 PREDDVOR
SLOVENIJA
P: +386 4 25 35 450
F: +386 4 25 35 454
E mail:[email protected]
www.kuzma.si