beautypg.com

Carbine PLUS-5500 User Manual

Page 2

background image

R

R

Lock

Unlock

Panic

Aux

Unlock

Lock/
Panic

2

Congratulations on your purchase of a quality Carbine Automotive security system. Carbine automotive
security products have been designed to provide the consumer with a product that is technologically
superior and will provide years of trouble free operation.

The information enclosed will provide a ready reference of the operation and maintenance of your new
Carbine security system.

Remote Control Transmitters

1. Exit the vehicle and close all entrances.
2. Press and release the LOCK button on the transmitter. The security system will respond as follows:

A. The horn/siren will chirp one time.
B. The LED indicator will begin to flash at a steady rate.
C. The parking lights will flash one time.
D. The starter disable device will become armed and the vehicle engine will not crank
E. All protected entrances are armed.
Note: If the dome light is on or a sensor is active at the time you arm your security system, You will

hear the horn/siren beep one time and then you will hear another beep from the horn/siren about 5
seconds later. This second beep is the active sensor warning indicator. This second beep tells you
that the alarm is armed but one of the sensors has been temporarily deleted because it was on at
the time the alarm was armed.

The security system is now fully armed!

Security System Operation:

(Using the transmitter to arm the security system)

Regular

A

Code
Hopping

Aux

Your Carbine security system can operate from any one of the three transmitters shown here. Locate the
transmitter that was supplied with your system and use the drawing as a ready reference while reading
through the operating procedures.

C

R

Passive

B

Note: The following information is valid only if your security system has been programmed to
automatically arm.

1. Turn off the ignition key and exit the vehicle.

2. Close all protected entrances. After the last protected entrance is closed the horn/siren will chirp one

time and the LED indicator will begin to flash fast. The fast flashing LED indicates that the automatic
arming timer is counting down and the security system will become armed within 30 seconds. After 30
seconds has passed, the security system will respond in the following manner:

Automatic Arming (Without Using the Transmitter)

Lock

Unlock

Panic

Aux

Passive

Unlocking