Using your remote control – Code Alarm CA 2050 User Manual

Page 3

Locking the Vehicle

To lock the vehicle, exit the vehicle, close all doors, then press the button. The
parking lights will flash 2 times, indicating the system has locked the doors and
activated the starter interrupt feature (if equipped and connected). The LED status
indicator will blink steadily, once per second.

NOTE: The system is defaulted with Silent Choice enabled, which requires a
second press of the button to activate an audible arming response from the
vehicle.

Unlocking the Vehicle

To unlock the vehicle press the button. The parking lights will flash 1 time,
indicating the system has unlocked the doors and disabled the starter interrupt
feature (if equipped and connected).

NOTE: The system is defaulted with Silent Choice enabled, which requires a
second press of the button to activate an audible arming response from the
vehicle.

*Throughout this manual, ‘press’ refers to pressing for less than 1 second; ‘press and hold’ refers to pressing for more
than 2 seconds.

Using Your Remote Control

Valet Mode

To engage valet mode:

1. Turn the ignition key to the ON position.
2. Press and hold the emergency override button.
3. The LED will light solid indicating that the system is in valet mode.

When valet mode is activated the status LED will light solid, and the starter
interrupt feature will be disabled.

To disengage valet mode:

1. Turn the ignition key to the ON position.
2. Press and release the emergency override button.
3. The LED will turn off indicating that the system has exited valet mode.