Philips 30PW8502-37 - Manual (Page 28)

How TO USE THE S leeptimer C ontrol
Have you ever fallen asleep in front of the TV,
only to have it wake you up at two in the
morning with a test pattern sound screech­
ing in your ears? Well, your TV can
enable you to avoid that discomfort hy
automatically turning itself off. With the
Sleep Timer feature, you can set a timer to
automatically switch the TV OFF after a
period of time you choose (15-minute
mcrements up to 60 minutes, then 30-
minute increments up to 90 minutes, then
60-minute increments up to 240 minutes).
^ Press the SLEEP button on the
i remote control. The SLEEP timer
ft onscreen display will appear in the
upper part of the screen.
Within five seconds, press the
SLEEP button repeatedly to pick the
amount of time (15-minute increments
up to 60 minutes, then 30-minute
increments up to 90 minutes, then 60-
minute increments up to 240 minutes)
before the TV will turn itself off.
An onscreen countdown will appear during
the last minute before the TV shuts itself off.
During the last minute of a
SLEEP timer setting, an onscreen
countdown will be displayed. )15
During the last 10 seconds of a
SLEEP timer setting, an onscreen
display will read GOOD BYE.
l/i:i.ri I I. Ili.vr
To see how many minutes remain before the TV
shuts itself off, press the STATUS/EXIT button.
A Sleep Timer setting can be cancelled by press­
ing any button during the last minute of the oper­
ation.
Sop 30
)45
Seep 60
Seep 90
>120
>180
>240
How TO USE THE F reeze C ontrol
T Tavfi you ever wished you could freeze the
TT picture on the television broadcast to
write down a special telephone number or to
capture a needed address? Your television
will allow you to do just that with the press of
just one button on the remote control.
With a signal on the television screen,
i simply press the FREEZE button on
ft the remote control to stop the picture
at any given moment.
Press the FREEZE button on the
remote control again to resume normal
viewing.
Illli.ri 11. l/l.M
After freezing a picture on the screen, when the
FREEZE control is turned OEE, the nonnal sig­
nal programming will be shown at it’s present
time. The signal that was being shown while the
picture was frozen will not be viewable.
28