Creda Single Oven - Manual (Page 33)

33
Before calling a Service Engineer, please check through the following lists.
THERE MAY BE NOTHING WRONG.
SOMETHING WRONG?
Problem
Nothing works.
Display shows 0.00 AUTO.
Timer display shows " Auto " lit up
or flashing.
Timer display correct but
appliance will not operate
Can not set an “Auto Cook”
programme
Draught from beneath control
panel.
Cooling fan not operating
Oven burner not working
Slight smell of gas after closing
oven door.
Oven appears to be cooking at too
high a temperature.
Timer buzzer/bleeper operates
continually
Check
If the timer display is blank.
Then it is likely that there is no electricity supply to your oven.
Check: (i) That the main cooker wall switch is turned on.
(ii) Check other appliances to see if you have a power
cut.
(iii) Check the main circuit breaker for the property.
The power supply to your oven has possibly been interrupted, but has
now come back on again. Reset the timer to the correct time of day and
"Manual" operation using instructions given in the timer section of the
book.
To use the ovens or grill the timer must be set to manual mode. See timer
instructions.
The appliance incorporates a safety device to shut down the burners in
the event of a fault, to prevent overheating.
In this case contact your service engineer to have the fault rectified and
the safety device reset.
Remember that " Cook period " is the actual length of time for which
the timer will switch the oven(s) on as part of an "Auto cooking "
programme.
A gentle flow of air will be blown from beneath the control panel when
the appliance is used. If the appliance is still warm, this cooling fan may
continue to run, or restart itself after all controls have been turned off.
The fan will stop once the appliance has cooled.
If no air is blown from below the control panel when the controls are
switched on and you have checked through the " Nothing works "
section above, then the cooling fan may be faulty. In this case you
should turn off the appliance and contact your service agent to arrange
for a repair.
Note that the oven burners only operate when the door is closed to
ensure safe operation and avoid wasting heat. With the door closed the
oven burner will ignite.
This is due to the short delay while the burner reignites and will soon
disperse.
It may be necessary to turn to a lower setting than shown on the cook-
ing chart or recipe as results depend on personal tastes.
If the oven appears to be cooking at too high a temperature than
previously, and turning down the thermostat has no effect, then the
thermostat may be faulty and you should contact your service agent.
Buzzer / bleeper should stop automatically after two minutes. If not.
press minute minder button to silence.
If you have been through the above list and there is still a problem;
Contact Service (see Key Contacts, back page).