Chicago Electric SPOTLIGHT 30 MILLION CANDLEPOWER 93175 - Manual (Page 4)

SKU 93175 For technical questions, please call 1-800-444-3353 Page 4
Unpacking
When unpacking, check to make sure the following parts are included. If any parts
are missing or broken, please call Harbor Freight Tools at the number on the cover
of this manual.
AC Charger Plug (8) Car Charger Plug (7)
Charger Status
Indicator LEDs
On/Off Switch (6)
Lens and Reflector (5)
Shoulder Strap (4)
Stand (3) Stand Lock
Battery (2)
Back Cover
Cover Latch Rubber Handle
Grip
11. Always recharge the Battery when the Spotlight performance begins to
diminish. Severe heat is most destructive to a Battery; the more heat
generated, the faster the Battery loses power. A Battery that gets too hot can
be permanently damaged. Never over-discharge a Battery by using the tool
even after tool performance is decreasing. When tool performance begins to
diminish, stop the tool, and recharge the Battery.
12. Always remove the Battery from the Spotlight before performing inspection,
maintenance, cleaning procedures, or storage.
Warning: The warnings, cautions, and instructions discussed in this instruction
manual cannot cover all possible conditions and situations that may occur. It
must be understood by the operator that common sense and caution are fac-
tors which cannot be built into this product, but must be supplied by the opera-
tor.
Charging Battery
Caution: Set the Spotlight Switch (6) to the Off position before charging. Never
charge the Battery (2) for over 7 hours. Charge only until the green LED Bat-
tery Status Indicator comes on. Do not operate the Spotlight while charging.
1. Unlatch the Cover Latch and open the Back Cover of the Spotlight as shown
above, right.
2. Pull out and unwind the desired charging cord: the AC Charging Plug (8) for
charging from a 110 VAC electrical outlet, or the DC Car Charger Plug (7) for
charging from a car outlet.