CatEye EC-8OOOU - Manual (Page 12)

Copyright© 1996 Cateye Co., Ltd.
Printed in Japan ECME80U-9807220
0689027
1
CO.,LTD.
Troubleshooting
1 Checking the problem first
Before suspecting the failure of the unit, check the fol-
lowing point:
No display on screen at all.
Display is unusual.
Check if the batteries have run short.
Replace all of four batteries with brand-new ones.
Beep would not stop.
Have you set your age correctly?
Setting of age will automatically set the upper pulse
limit. Set your correct age.
The progress to target has been reached quickly.
Have you set the target time or target calorie?
Set the values in accordance with your exercise pro-
gram.
No display of heart rate on screen
Have you set the earlobe sensor of pulse sensor cor-
rectly?
Set the sensor at the center of your earlobe.
The sensor should be set after removing earrings
Is the pulse sensor plug firmly connected?
Insert the plug correctly.
Has the pulse sensor been damaged?
Check the pulse sensor according to the check proce-
dure.
If it is found damaged, replace it with a brand-new one.
Unusually high heart rate is displayed.
Check the pulse sensor according to the check proce-
dure.
If it is found damaged, replace it with a brand-new one.
2 Limited warranty
• Cat Eye Co., Ltd. guarantees that the Cateye Ergociser
Model EC-8000 is free from material defects and malfunc-
tions, for a period specified in the separate Warranty Card.
In case there should be defects or malfunctions under cor-
rect and normal personal use, Cat Eye will repair or re-
place the unit or parts, according to the terms and condi-
tions mentioned in the Warranty Card.
• If repair service is required, contact the dealer where you
purchased the unit.
• The warranty covers only the main resistance unit and the
control panel. Accessories such as pulse sensor, and me-
chanically consumable parts are not covered.
Specifications
Load: Eddy current system utilizing permanent magnet
Load adjustment: 8-step adjustment by using manual lever
Load range: approx. 10 - 240 watts (subject to pedal cadence)
Acceleration: 2-step acceleration by using a V-rib belt
Control system: 4-bit microcomputer
Display: LCD
Display function:
Function Range Accuracy
Heart rate 50-220 /min
±
1bpm (stable state)
Cadence 40-80 rpm 9-step graph
Elapsed time 0min00sec-99min59sec
±
0.003%
Work rate 0-999 watts ± 5watts at 50watts
Calorie consumption 0-999 kcal Estimated value
Progress to target remaining 8/8-0/8 8-segment graph
Pedal resistance 1-8 levels 8-segment graph
Screen display Display in input screen or exercise screen
Heart mark Blinks to heart rate
Battery mark Illuminates when batteries run short
Error mark Illuminates when fails to detect the pulse sen-
sor signal
Pulse sensor OK mark Illuminates at the time of pulse sensor test
Setting function
Age 10-99 years of age (initial value: 40)
Target time 0-99 min. (initial value 20)
Target calorie 0-999kcal (initial value 0)
*Either of target time or target calorie can be set.
Upper pulse limit Automatically set (200–age) by inputting the
value for age.
*Setting can be changed by operating a button.
Alarm function
Upper pulse limit alarm: Beep sound when the heart rate exceeds
preset upper pulse limit
Target achievement alarm: Beep sound when the target time or tar-
get calorie setting has been reached.
Power supply: AA(R6) x 4
Battery life: Approx. 200 hours (by alkaline batteries)
User's weight limit: 286 lbs (130 kg)
Measurement: 22-1/16 x 51-31/32 x 39-25/32” max
(560 x 1320 x 1010 mm)
Weight: approx. 68 lbs (31 kg)
*Specifications and design subject to change without notice.
2-8-25, Kuwazu, Higashi Sumiyoshi-ku, OSAKA, 546-0041 JAPAN
PHONE: 81-6-719-7781
FAX:
81-6-719-2362
Made in Japan