beautypg.com

Programming your coffeemaker, Setting the clock, Charcoal water filter – Cuisinart DCC-750 User Manual

Page 7

background image

PROGRAMMING YOUR

COFFEEMAKER

SETTING THE CLOCK

When the coffeemaker is plugged in,

12:00 will appear until you set the time.

Hold down the Hour or Minute button until

the clock begins flashing. Press either

button to select the desired time. Hold

buttons down to scroll through the digits,

or press and release to advance one digit

at a time. When scrolling, the numbers will

advance slowly and then speed up. When

the number displayed approaches the

desired time, press and release to advance

one digit at a time. Be sure the PM

indicator is on if a PM time is desired.

SETTING THE AUTO ON TIME

1. Press and hold the Program (PROG)

button until the display flashes. You

are now in program set mode.

2. Follow directions under SETTING

THE CLOCK (above) to program your

start-brew time.

3. Press the start button to exit program

set mode. Mode will be exited

automatically if no button is pushed.

The green indicator light should be

illuminated to indicate that the Auto

On function is on.

NOTE: To start brew time at the same time

the next day, simply press PROG. When

green indicator light comes on, brewing will

start at the time you’ve selected.

SETTING THE AUTO OFF TIME

1. Press and release the AUTO-OFF

button until the display flashes.

2. Follow directions under SETTING

THE CLOCK (above) to program your

coffeemaker to shut off from 0 to 4

hours after brew cycle is finished.

CHARCOAL WATER FILTER

Your coffeemaker comes with a
charcoal water filter that eliminates
chlorine, bad tastes and odors from
tap water.

Inserting the Water Filter
• Remove the filter from polybag and

soak it, fully immersed, in cold tap
water for 15 minutes.

• Lift the water filter holder out of the

water reservoir (see diagram, page 5).

• Press down on the filter compartment

and pull toward you to open.

• Place filter into the holder and snap

it closed. Be careful – improper
placement can tear the filter skin.

• Flush filter by running cold tap water

through holes in bottom of
compartment for 10 seconds.

• Allow the filter to drain completely.
• Slide the water filter holder back into

the channel in the water reservoir,
pushing it down to the base of the
unit.

NOTE: We recommend
changing the water filter
every 60 days or after
60 uses, and more
often if you have
hard water.
Replacement filters
can be purchased in
stores, by calling
Cuisinart

®

Customer
Service, or at
www.cuisinart.
com.