Clarion WH200 User Manual

Page 7

ATTERY

NSTALLATION

1. Open the battery compartment by sliding the cover

toward the bottom of the Headphone.

2. Place two (2) alkaline AAA batteries into the battery

compartment of the Headphones, making sure that the
battery polarity is correct.

3. Snap the battery cover back into place.

PERATION

ESCRIPTION

PLEASE READ CAREFULLY TO PREVENT DAMAGE TO THE
HEADPHONES OR YOUR EARS.

1. Be sure batteries are properly installed in the

Headphones.

2. Turn the Headphone volume nearly off before turing on

the power switch.

3. Turn the Headphone power switch to the ON position.

4. Place the headphones on your head and the power indica-

tor will illuminate.

5. Adjust the Headphone volume to a comfortable listening

level.

Channel A/B Selection Switch

1. Select the appropriate channel (A/B) for the desired audio

source signal.

NOTE: Remove headphones and lower volume before switch-
ing between channels. The signal on one channel may be
louder than the other, resulting in possible hearing damage.

Figure 3. The Remote Headphone Battery Installation.

OWNER’S MANUAL/INSTALLATION GUIDE