beautypg.com

Driving in snow, mud and sand, Hill climbing – Jeep 2011 Liberty User Manual

Page 337

background image

Maintenance
After driving through deep water, inspect your vehicle
fluids and lubricants (engine, transmission, axle, transfer
case) to assure they have not been contaminated. Con-
taminated fluids and lubricants (milky, foamy in appear-
ance) should be flushed/changed as soon as possible to
prevent component damage.

Driving In Snow, Mud And Sand

In heavy snow, when pulling a load, or for additional
control at slower speeds, shift the transmission to a low
gear and shift the transfer case to 4WD LOW if necessary.
Refer to “Four-Wheel Drive Operation” in “Starting and
Operating” for further information. Do not shift to a
lower gear than necessary to maintain headway. Over-
revving the engine can spin the wheels and traction will
be lost.

Avoid abrupt downshifts on icy or slippery roads be-
cause engine braking may cause skidding and loss of
control.

Hill Climbing

NOTE:

Before attempting to climb a hill, determine the

conditions at the crest and/or on the other side.

Before climbing a steep hill,

shift the transmission to a

lower gear and shift the transfer case to 4WD LOW. Use
first gear and 4WD LOW for very steep hills.

If you stall or begin to lose headway

while climbing a

steep hill, allow your vehicle to come to a stop and
immediately apply the brakes. Restart the engine and
shift to REVERSE. Back slowly down the hill allowing the
compression braking of the engine to help regulate your
speed. If the brakes are required to control vehicle speed,
apply them lightly and avoid locking or skidding the
tires.

5

STARTING AND OPERATING

335