Jeep 2013 Compass User Manual

Page 381

If the ignition key is cycled, this sequence will repeat,
providing the system fault still exists. If the system fault
no longer exists, the Tire Pressure Monitoring Telltale
Light will no longer flash, the

ЉSERVICE TPM SYSTEMЉ

text message will not be present, and a pressure value
will be displayed instead of dashes. A system fault can
occur with any of the following scenarios:

1. Jamming due to electronic devices or driving next to

facilities emitting the same radio frequencies as the
TPM sensors.

2. Installing some form of aftermarket window tinting

that affects radio wave signals.

3. Snow or ice around the wheels or wheel housings.

4. Using tire chains on the vehicle.

5. Using wheels/tires not equipped with TPM sensors.

The EVIC will also display a

ЉSERVICE TPM SYSTEMЉ

message for a minimum of five seconds when a system
fault related to an incorrect sensor location fault is
detected. In this case, the

ЉSERVICE TPM SYSTEMЉ

message is then followed with a graphic display with
pressure values still shown. This indicates that the pres-
sure values are still being received from the TPM sensors
but they may not be located in the correct vehicle
position. The system still needs to be serviced as long as
the

ЉSERVICE TPM SYSTEMЉ message is displayed.

NOTE:

Your vehicle is equipped with a compact spare

wheel and tire assembly.

1. The compact spare tire does not have a tire pressure

monitoring sensor. Therefore, the TPMS will not moni-
tor the tire pressure in the compact spare tire.

STARTING AND OPERATING

379