Ss ee tt uu pp ii nn ss tt rr uu cc tt iioo nn ss – Intex Pool Ladder For 52in (132 cm) model 2012 User Manual

Page 7

92PO

SAVE THESE INSTRUCTIONS

Page 7

(92PO) 52" 2-SECTIONS POOL LADDER ENGLISH 7.5” X 10.3” PANTONE 295U 10/13/2011

English

IIOO

LADDER SETUP (continued)

3. STEP INSTALLATION (refer to figures

2.1 through 2.3):
Take one complete “A” leg and one
complete “B” leg. The steps (6) attach
to the mounting fixtures on each leg.
Note the markings “A” and “B” next to
each attachment slot on each step. “A”
side of the step attaches to “A” leg
and “B” side of the step attaches to
“B” leg - see figure 2.1.
Slide the step over the mounting
fixture on the leg and push it all the
way until it is completely flush with the
mounting fixture.
Any protrusion of the mounting
fixture beyond the step indicates
the step is upside-down or
otherwise wrongly positioned.
After ensuring the step is placed
correctly, push the mounting pins (5)
into the holes on the step, securing
the step to the mounting fixture – see
figure 2.2 (four pins for each step).
Repeat the process with the remaining
steps and with the remaining pair of
legs. When finished, you will have two
complete sides of the ladder. Each
side should resemble figure 2.3.

4. TOP PLATFORM INSTALLATION

– ONE SIDE AT A TIME (refer to
figure 3):
Identify hole “A” and hole “B” on the
top platforms (2), marked accordingly
at each corner. Slide the top platforms
over the legs, making sure hole “A” of
one corner of platform slides over leg
“A” and hole “B” of the other corner of
platform over leg “B”.
The small holes on the side of
platform should align with the lower
holes on the legs. Fasten each
platform to the legs using the longer
fasteners/screws (4).
Do not yet attach the other side of the
ladder to the top braces – this
assembly step will follow later.

2.3

2.2

2.1