Intex Pool Ladder Barrier 20125 - Manual (Page 2)

136
(136) LADDER BARRIER ENGLISH 7.5” X 10.3” 09/07/2009
SAVE THESE INSTRUCTIONS
Page 2
1. Unfold or extend the barrier and connect the pole at the top and bottom by squeezing the push buttons on the pole
and inserting the poles in place until the push buttons snap back into the designated holes (See drawing 1).
2. Depending on the size/height of the ladder, the barrier includes 2 clamps for the 36” and 42” ladders or 3 clamps for the
48” and 52” ladders. Slide one clamp along each railing fitting on the barrier (see drawing 2).
3. Lay the assembled ladder on its side on the ground to facilitate the mounting of the assembled barrier to the ladder.
4. Starting from the bottom step of the ladder, attach the clamp tightly to the center back side of the ladder steps.
DO NOT ATTACH TO THE FRONT OR ANY OTHER PLACE ON THE LADDER! Do this by sliding the clamp upward
onto the back side of the step and make sure it is centered. Note the vertical slot on the clamp, which fits exactly over
the center ridge on the underside of the step (see drawing 3). Tighten the screw with fingers only.
Using the wrong barrier in the swimming pool will prevent it from functioning properly and may result in hazard
that can cause entrapment and serious personal injury or drowning. Make absolutely sure to determine the
correct ladder barrier for your style of pool. In case of two or three barriers do not use the remaining/unused
barriers for any other purposes.
WARNING
SETUP INSTRUCTIONS
2
36” & 42”
ladders
48” & 52”
ladders
3
Metal Frame Pool Easy Set ® Pool 1
2
1
center