Chicago Electric ROUTER TABLE WITH ROUTER 95380 - Manual (Page 15)

SKU 95380 For technical questions, please call 1-800-444-3353 PAGE 15
INSPECTION, MAINTENANCE, AND CLEANING
1. CAUTION! Always make sure the Power Switch of the Router Table is in
its “OFF” position and the Router Table is unplugged from its electrical outlet
prior to performing any inspection, maintenance, or cleaning procedures.
2. Before each use, inspect the general condition of the Router and Router
Table. Check for misalignment or binding of moving parts, cracked or
broken parts, damaged electrical wiring, and any other condition that may
affect their safe operation. If abnormal noise or vibration occurs, have the
problem corrected before further use. Do not use damaged equipment.
3. To clean the exterior of the Router and Router Table, use only a clean cloth
and mild detergent. Do not immerse any part of the unit in liquid.
4. To clean or replace the Carbon Brushes (32A): It may become necessary
to clean or replace the two Carbon Brushes when the Motor performance
decreases, or stops working completely. The Carbon Brushes are located
on each side of the Motor Housing (36A). To do so, remove the two Brush
Holders (31A). Then, remove the two Carbon Brushes from the Brush Holders.
If the Carbon Brushes are worn down more than 1/2, replace both Carbon
Brushes. If, however, the Carbon Brushes are just dirty they may be cleaned
by rubbing them with a pencil eraser. When installing the Carbon Brushes,
make sure brushes are in the same position and direction as before they were
removed. Make sure the carbon portion of the Carbon Brushes contact the
Stator (23A) assembly and the springs face away from the Motor. Also, make
sure the springs operate freely. After cleaning or replacement, replace the Brush
Holders.
NOTE: New Carbon Brushes tend to arc or spark when first used until
they wear and conform to the Stator assembly. (See Assy. Diagram.)
5. CAUTION! All maintenance, service, or repairs not mentioned in
this manual must only be performed by a qualified service technician.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY
DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE
OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER
AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS
SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER.
THE BUYER ASSUMES ALL RISKS AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE
ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER
INSTALLATION OF REPLACEMENT PARTS THERETO.