CLIFFORD 60 - Manual (Page 17)

To exit valet mode
1. Turn the ignition switch to its “ON” position or start the engine (you may also
perform the following while driving).
2. Flick the switch back to its center position. The LED will turn off to confirm that the
system is now in its normal operating mode.
Remote controlled valet mode entry and exit
You can even enable or exit valet mode with your remote control simply by transmitting
channel 9 (LevelShift twice, then button 1). In addition to the above indications, two
parking light flashes will confirm that you have remotely enabled valet mode, while a
single flash confirms exiting of valet mode.
Keyless entry in valet mode
Even if valet mode is enabled, you can still remotely control the convenience features.
For instance, simply press button 1 (channel 1) as if you were disarming and the doors
will unlock (indicated by one parking light flash) and the interior lights will turn on.
Press button 1 again and the doors will lock (confirmed by two flashes). You may also
use the other channels to activate options such as a remote trunk release or remote
engine starting.