Crane & Co. EE- 5200 W / B - Manual (Page 6)

5
BEFORE FIRST USE
CHECK HUMIDIFIER PLACEMENT - Place the Humidifier on non-metallic, lint free,
waterproof, level surface for best performance. This is to help disperse the mist in the
air, and prevent it from being knocked or tipped over.
CHECK WATER LEVEL SENSOR - Make sure that the water level sensor is secured
properly. Refer to “cleaning and maintaining water level sensor” on page 9 for
instructions on how to clean water level sensor.
CAUTION:
DO NOT operate the humidifier without water in the water tank.
DO NOT plug in the cord with wet hands; electric shock could happen
1. Be sure the humidifier is switched to OFF and the unit is disconnected from
electrical outlet.
2. Select a location for your humidifier. On a flat surface, about 4 inches away from
a wall.
3. DO NOT place the humidifier on a finished floor or near furniture, which can be
damaged by moisture or water. Place on a water resistant surface.
4. DO NOT place Humidifier on top of a towel, or a carpeted surface. The air vent on
the bottom may become blocked, and overheat the humidifier.
OPERATION AND USE
1.
Lift the water tank off the humidifier base.
2. Turn over the water tank and unscrew the water tank cap
at the bottom of the tank by turning it counterclockwise.
(See Fig. 6)
Fig. 6
3. Fill water tank with cold water; do not fill all the way to
the rim. DO NOT CARRY FULL WATER TANK BY
HANDLE. ALWAYS HOLD FULL WATER TANK WITH TWO
HANDS ON EITHER SIDE OF WATER TANK.
(See Fig. 7)
DO NOT use hot water. Use cool tap water.
DO NOT add any medication to the water
DO NOT pour water into Mist Channel.
DO NOT overfill medicine cup and allow medicine to
spill into mist chamber.
Fig. 7