beautypg.com

CLIFFORD ACE 7500 User Manual

Page 6

background image

Add ing new re mote con trols

For other drivers, or to control Clifford G4 systems on your other cars with the same remote, you can buy additional remote controls from any Clifford

Dealer (or direct from the Customer Service Department of your nearest Clifford Headquarters listed on the front cover) and program them into the

system yourself. Your ACE 7500 will respond to as many as four remote controls.

NOTE: Clifford G4 systems will re spond only to G4-type ACG 2 re mote con trols. Older Clif ford ACG and non- ACG
re mote con trols are not com pati ble with G4 systems.

To add a new master 5-button remote control, use the Add new master remote feature (column 1, row 1) of the User-selectable features table. To add a new

companion 4-button remote, program each button and button combination to the specific functions noted in column 4.

Two-Point AutoIm mo bi li za tion

While armed, your system immobilizes both the starter and ignition systems of your vehicle to prevent a thief from starting the engine. The engine will

remain immobilized even if a thief were to cut power to the system or find and remove the system control unit.

Op tional Wire less Im mo bi lizer™

Clifford’s optional Wireless Immobilizer interrupts a third point in the vehicle, such as the fuel pump. This Clifford innovation provides immobilization

without any wires to the control unit, so a thief could not find the Wireless Immobilizer even if he tried tracing the system wires! Operation of the

Wireless Immobilizer is automatic and user-transparent.

BE sure to keep the rec ord your Clif ford in staller pro vides as to the lo ca tion of the Wire less Im mo bi lizer in case your
ve hi cle needs fu ture serv ic ing.

NOTE: If your vehicle’s engine ever stalls, the Wireless Immobilizer WILL engage. You must turn the ignition all the
way to “OFF” in order to restart.

False Alarm Pre ven tion & FACT™

With FACT (False Alarm Control and Test), you’ll never experience repeated false alarms. If the siren sounds, DO NOT disarm; allow it to run for the

full siren duration. Before sounding the siren a second time, the system automatically checks for another activated sensor or trigger to verify that an

intrusion is in progress. This feature is user-selectable.

How to in ter pret the LED status in di ca tor

LED Con di tion

Mean ing

Off

System is disarmed and in normal operating mode (i.e., valet mode is off)

On

Valet mode is on, the vehicle may be entered without having to disarm

Flashing rapidly (ignition off)

System is armed and protecting your vehicle

Flashing rapidly (ignition on)

BlackJax anti-carjacking mode has been engaged, enter your valet/disarming code IMMEDIATELY

Flashes, pause, flashes

Either an error (such as arming with the trunk open) or indicates the trigger or sensor that was tripped

Auto mat ic Battery- Saving Mode

To conserve vehicle battery power (the LED actually draws more current than the entire control unit), if the system has remained continuously armed for

48 hours, the flash rate will automatically slow to half the normal rate. After 96 hours, it slows to one-quarter.

User- Selectable AutoArming™

If you forget to remotely arm, the system automatically arms itself 30 seconds after the doors are closed. For your convenience, if you re-open any door(s) within

the 30-second countdown, AutoArming restarts the 30-second delay from the beginning after all doors are closed. ACE 7500 has these additional features:

n

AutoArming entry delay:

If you temporarily lose the use of your remote controls, you may turn on the AutoArming entry delay feature. If this

feature and AutoArming are turned on, it allows you to enter the car (if it previously AutoArmed) and silently disarm the system by turning on the

ignition within 15 seconds of opening the door. See User-selectable features (column 3, row 3).

n

Visual acknowledgment:

Five seconds after you exit, close all the doors and the interior light has turned off, the indicator lights flash twice to

confirm the AutoArming countdown is progressing. Then, 25 seconds later, the system will AutoArm.

n

Lock upon AutoArming:

To ensure you can’t accidentally lock your keys inside the car, the system is factory-set not to lock the doors upon

AutoArming. To change this setting, see User-selectable features.

n

Instant AutoArming bypass:

Prevents AutoArming when fueling the vehicle and at other times when you wish to temporarily bypass

AutoArming. To activate Instant AutoArming Bypass, rapidly turn the ignition switch to “ON” then “OFF.” You will hear a siren chirp to confirm

that the system will not AutoArm. The system automatically reverts to its normal operating mode when you next start the engine.

User- Selectable Head light Re minder

You can set your system to issue a warning tone if you attempt to exit the vehicle without turning off the headlights. Since many vehicles already have a

similar feature, or have delayed headlights, this feature is factory set to off.

6