Compatible Systems DS3 - Manual (Page 13)

Chapter 2 - Quickstart Instructions 9
Box (under Global/IP Static Routes) to set static routes. OSPF and BGP can only be config-
ured using text-based configuration.
TB: Use configure and set either the RIPVersion keyword or the OSPFEnabled keyword in
the IP WAN 0 section. Add static routes and a default router using the edit config IP Static
command.
v Note: Due to the complexity of BGP, configuration parameters for BGP are not given in this
Quickstart. For help with BGP configuration parameters, and other configuration questions,
refer to the Tech Support pages on the Compatible Systems Web site at:
http://www.compatible.com/.
IPX Protocol
Required for IPX
Frame Relay operation requires that the WAN interface be set as an IPX “numbered inter-
face.” This means that the interface (and thus the Frame Relay network) must have an IPX
network number.
• IPX numbered interface
• IPX network number
CV: Use the IPX Routing: WAN Dialog Box.
TB: Use configure and set the Numbered and Net keywords in the IPX WAN 0 section.
Suggested for IPX
The settings above are all that is generally required for IPX operation over Frame Relay.
AppleTalk Protocol
Required for AppleTalk
Frame Relay operation requires that the WAN interface be set as an AppleTalk “numbered
interface.” This means that the interface (and thus the Frame Relay network) must have an
AppleTalk network number and an AppleTalk node number.
• AppleTalk numbered interface
• AppleTalk network number
• AppleTalk node number
• AppleTalk zone name
CV: Use the AppleTalk Routing: WAN Dialog Box.
TB: Use configure and set the Numbered, NetLower, and DefZone keywords in the Apple-
Talk WAN 0 section.
Suggested for AppleTalk
The settings above are all that is generally required for AppleTalk operation over Frame Relay.
DECnet Protocol
Required for DECnet
In order to be used, DECnet must be turned on both globally and for a particular port.
WAN interfaces which are set for Frame Relay operation do not need any additional parame-
ters set in order to function.
• Set DECnet on (globally, and for this port)
CV: Use the DECnet Routing Dialog Box (under Global/DECnet Routing) and the DECnet:
WAN Dialog Box.