Country Home Products SUBURBANTM - Manual (Page 22)

DR ® POWERWAGON ™ Safety & Operating Instructions 16
Removing the Front Wheels
Tools & Supplies Needed:
• (2) 7/16" wrenches
• block to raise machine off ground
!
WARNING: Always disconnect the
spark plug wire before servicing your
machine.
1. Block the machine so the wheel is an inch
or two off the ground.
2. Using (2) 7/16" wrenches, loosen the bolt
(Figure 32) and slide the wheel off the
axle.
Adjusting the Shift Lever
If you are unable to shift into reverse or 2nd gear, the shift lever and tie rod need to
be adjusted.
Tools needed:
• (2) 1/2" open-end, adjustable or socket
wrenches
!
WARNING: Always disconnect the
spark plug wire before servicing your
machine.
1. Remove the dump body.
2. Move the shift lever into the reverse
position.
3. Loosen and remove the tie rod nut and
bolt from the transmission arm (Figure
33). Unhook the tie rod from the
transmission arm.
4. Fully extend the transmission arm toward
the rear of the DR ® POWERWAGON ™ ,
this will put it in reverse gear.
5. Loosen the lock nut on the eye bolt
(Figure 34), and turn the eye bolt one turn
at a time to take up slack in the tie rod.
Place the tie rod back on the transmission
arm, insert the nut and bolt and retighten.
This should enable you to engage the full
range of gears.
Figure 32
Figure 33
Figure 34