Philips AJ 3040/00P - Manual (Page 4)

Installation Radio/Clock
BUTTONS RADIO
® TIME SET switch:
- TIME - for setting the time
- RUN - normal position
- ALARM - for setting the alarmtime
d) ALARM svi/itch:
- OFF - alarm off
- RADIO - for waking up by radio
BUZZER - for waking up by buzzer
HOUR button - for setting the hours
0 RADIO ON/SLUMBER - to switch on the radio
® MIN button - for setting the minutes
0 SLUMBER OFF / REPEAT ALARM button:
- To switch off alarm temporarily
- To switch off the radio
0 Clock display with ALARM- and PM- indicator
(not all versions)
(|) BATTERY DOOR
(9; VOLUME control - for adjusting the volume
TUNING dial - for locating the required station (1$'
(y) BAND switch - for selecting w'avebands
MAINS CONNECTION
• Check if the mains voltage as shown on the
type plate on the base of the set corresponds
to your local mams supply.
If It does not, consult your dealer or service
organisation.
• As soon as you insert the mams plug into the
wall socket, the figures on the display®' will
blink. This means that you must set the correct
time.
• To disconnect the set from the mams
completely, withdraw the mams plug from the
wall socket.
For users in the UK: Please follow the
instructions on page 6.
RADIO ON
You can use this clock radio solely as a radio
• Set the TIME SET switch ?! to RUN,
• Press the RADIO OM/SLUMBER button ?) to
switch the radio on. After 59 minutes the radio
will be switched off automatically.
• Select the waveband using the BAND switch
@-
• Locate the required transmitter using the
TUNING dial 0.
• Set the volume using the VOLUME switch ifn
RADIO OFF
You can switch off the radio before the slumber
time (59 minutes) has elapsed:
• Press the SLUMBER OFF/REPEAT ALARM
button 0
.
Aerials
- For FM reception there is an aerial wire at the
rear of the clock radio This wire must be
extended and, if necessary adjusted slightly, in
order to obtain good reception.
- The AM aerial is built into the clock radio. To
obtain optimum reception you may have to
adjust the position of the clock radio slightly
CLOCK ____________ ______________
Clock display
The clock indicates the time on the display. In
case of 12-hour clock system, the PM indicator
will light up (on=PM, off=AM). The ALARM
indicator comes on when you switch on the
alarm.
Adjusting the time
• Set the TIME SET switch 0 to TIME
• Set the correct time using the HOUR
1
5 > and
MINUTE®' outtons.
• Set the TIME SET switch iT' to RUN
O C O
U