Cabletron Systems BRIM E100 BRIM-E100 - Manual (Page 21)

Chapter 3: Installation
Page 3-4 BRIM-E100 User’s Guide
6. Carefully lower the Fast Ethernet Interface Module onto the standoffs
while inserting the connector pins of the Fast Ethernet Interface
Module into the connector on the BRIM-E100. See Figure 3-3.
Figure 3-3 Installing Fast Ethernet Interface Modules
7. Press down firmly on the Fast Ethernet Interface Module until the pins
slide all the way into the connector holes. Ensure that the Fast Ethernet
Interface Module seats flush on the standoffs.
8. Secure the Fast Ethernet Interface Module to the standoffs with the
three screws removed from the BRIM-E100 in steps 2 and 3.
CONNECTOR
1665_02
STANDOFF
FE-100TX 10
100
CONNECTOR
TX
RX BRIM-E100
book Page 4 Friday, April 19, 1996 9:53 AM