Philips AJ 3015/04 - Manual (Page 5)

ALARM OFF POWER FAILURE
You can.switch off the alarm in 3 ways;
Switching off the alarm for 9 minutes
• Press the REPEAT ALARM button With this
switch you temporarily switch off the alarm. After
nine minutes the alarm (radio or buzzer) will sound
again. If you press the REPEAT ALARM button @
again, the same will happen again. If the REPEAT
ALARM button @ is not pressed again, the alarm
will switch itself off after 1 hour and 59 minutes.
The following day the alarm signal will sound
again at the set alarm time.
Switching off the alarm for 24 hours
• Press the ALARM RESET button 0. The alarm is
now switched off for 24 hours and will sound
again the next day at the same time.
Switching off the alarm completely
• Set the ALARM switch © to OFF. On the display
the ALARM indicator will disappear and the
alarm will be switched off. If you wish to be
woken the following day again, you must reset
the ALARM switch to RADIO or BUZZER before
going to sleep.
SLUMBER__________________________________
The clock radio has a built-in slumber function.
This function enables you to listen to the radio
before you fall asleep. You will not have to switch
off the clock radio yourself. This will take place
automatically.
Slumber time
The time you listen to the radio before you fall
asleep is called the slumber time. The slumber
time is 59 minutes.
If you wish to slumber, carry out the following:
• Make sure the TIME SET switch © is set to RUN.
• Press the RADIO ON button (|). The display will
show a slumber time of 59 minutes..
Slumber off
You can switch off the radio before the slumber
time has elapsed:
• Press the RADIO OFF button ® and the radio
will be switched off.
- If the TIME SET switch © is in position TIME or
ALARM, the slumber function will not work.
-The slumber function does not affect the alarm.
-As soon as a power failure occurs, the complete
clock radio will be switched off.
-As soon as the power supply returns, the numbers
on the display start to flash. This indicates that you
must set the correct time on the clock.
-You can insert a 9 Volts pack battery (type 6F22)
in the clock radio. Should there be a power
failure, the clock will continue to function. You
will not see this, however, because the battery
does not illuminate the clock display. As soon as
the power is switched on again, the display will
indicate the correct time.
To be perfectly clear: Alarm, radio and display do
not work on battery.
• Before inserting the battery, connect the power
plug to the wall outlet.
• Place the battery in the compartment on the
bottom of the clock radio (see diagram).
-Replace the battery once a year. It cannot be
stated precisely how long the battery will last.
This depends completely on how often and for
how long the power supply fails. This varies from
country to country or even region to region.
MAINTENANCE
- If you do not intend to use the clock radio for a
long time, it is recommended to remove the plug
from the wall socket. In addition to this, it is
advisable to remove the battery from the clock
radio. This will prevent any danger of leakage and
the clock radio will not be damaged.
-Fingerprints, dust and dirt on the clock radio
should be removed using a clean and damp soft
cloth or chamois leather. When cleaning do not
use any products containing abrasive agents or
solvents (benzine, thinner, alcohol etc.). These
might affect the housing.
-Rain, dampness and extreme heat may damage
the clock radio. For this reason it should not be
placed in full sun or close to heating elements for
any period of time.
This product complies with the radio interference
requirements of the European Community.
The type-plate is located on the bottom of the
clock radio.