Philips MAGNAVOX AZ 1200/04 - Manual (Page 16)

TROUBLESHOOTING
m
3
(a
WARNING
If a fault occurs, first check the points listed
below before taking the set for repair.
U n d e r n o c ir c u m s ta n c e s s h o u ld y o u tr y
to r e p a ir th e s e t y o u r s e lf a s th is w ill
in v a lid a te th e w a r r a n ty .
If you are unable to solve a problem by
following these hints, consult your dealer or
service center.
Problem Possible cause Solution
No sound. VOLUME is not adjusted. Adjust volume.
no power
Headphones are connected. Disconnect headphones.
Power cord is not securely connected. Connect the power cord properly.
Batteries are dead. Insert fresh batteries.
Batteries are inserted incorrectly. Insert batteries correctly.
Trying to change over from AC power to Remove the power cord from the
battery supply without removing the power cord, unit's AC MAINS socket.
No reaction to Electrostatic discharge,
operation of any keys
Disconnect the set from power supply,
reconnect after a few seconds.
Poor radio reception Weak radio signal. Adjust the antenna for optimum
reception.
Interference caused by electrical equipment
like TVs, computers, engines, etc.
Keep the radio away from electrical
equipment
no o r E indication The CD is badly scratched or dirty. Replace or clean the CD.
No CD is inserted. Insert a CD.
The CD is inserted upside down. Insert CD with label facing up.
The laser lens is steamed up. Wait until the lens has cleared.
The CD skips tracks The CD is damaged or dirty. Replace or clean the CD.
SHumf
or PROGRAivi is active. Switch
off SHUFFIE or PROGRAM.
Poor cassette
sound quality
Dust and dirt on the heads, capstans or
pressure rollers.
Clean heads, capstans, and pressure
rollers.
Use of unsuitable cassette types
(METAL or CHROME) for recording.
Only use NORMAL type cassettes for
recording.
Recording does
not work
Cassette tab(s) may be snapped off. Apply a piece of adhesive tape over
the opening.
Remote control does Batteries are inserted incorrectly. Insert batteries correctly.
not function properly Batteries are dead. Insert fresh batteries.
l/u. UU9 omy;
Distance to the set Is too large. Reduce distance.
16