Coleman 5029 - Manual (Page 5)

■ NOTE: Observe heat
build up for a few
minutes to ensure
heater is lit. If heater
fails to develop
substantial heat, turn
heater “OFF” and repeat
lighting procedure.
To Light
cont
To Turn Off
■ Turn FUEL VALVE
to OFF.
■ Allow HEATER to
cool for 10-15
minutes.
DANGER
• EXPLOSION - FIRE HAZARD
• Never store propane near high heat, open flames,
pilot lights, direct sunlight, other ignition sources or
where temperatures exceed 120 degrees F (49°C).
To Store
Support Leg Assembly
Support Leg
Match Light
■ Hold match as shown.
■ Turn valve to ON
position.
■ Heater will ignite with a
brief visible flame after
10-12 seconds.
■ Heater is not adjustable.
5
■ A wire Support Leg is supplied with your unit as
an alternate means to support your heater.
■ Insert the wire Support Leg into the receiver holes
provided on each side of the heater head. Make sure
the support is fully inserted. The short wire studs
should rest against the metal heater head.
■ Before lighting, place the heater with Support Leg
on a flat and stable surface.
CAUTION
• When using the
Support Leg Assembly,
DO NOT leave the Cup
Holder Adapter on the
heater. Cup Holder Adapter