Philips A01-1106-0147 User Manual
Ph i li ps, Imageo, Candlelight
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
A01-1106-0147
816746
PH I LI PS
Imageo
Candlelight!
o
□-»0 DD
Philips Imageo CandleLights Installation Instructions
SAVE THESE INSTRUCTIONS
Thank you for buying the Philips Imageo Candlelight set.
By following the instructions you will enjoy the full
benefits of the Philips Imageo Candlelight products.
Check to make sure the package contains the following
items. The set consists of three Candle lights.
* 3 Imageo Candle lights
O * Adapter
• Charger
This product is intended for household use only.
OPERATING INSTRUCTIONS
Using the Innageo CandleLight Set
for the First Time
Before using the IMAGEO Candlelights for the first
time, charge them for at least 12 hours until the red
indicator lED on charger is off.
Connect the adapter (A1) to the charger (B1) with the
DC plug (A2).Then plug the adapter (A1) into a wall
socket.The indicator IED(B2) will now be red. Insert up
to three Imageo Candlelights (C) in the slots (B3) in the
charger.The Ni-MH batteries in the Candlelights are
now being charged. After about 12 hours the batteries
will be fully charged and the indicator lED switches off.
Remove the adapter from the wall socket. The Imageo
Candlelights can now be used for approximately 24
hours before recharging.
Some Philips Imageo Candlelights may light up while they
are being charged.This depends on the remaining battery
current. You can turn the Philips Imageo Candlelight off
simply by removing it from the charger and tilting it ©.
See also ‘Switching the Philips Imageo Candlelights On
and Off’.
Switching the Phiiips Imageo CandleLights
On and Off
© To turn on the Philips Imageo Candlelights, simply tilt
them. They can be switched off in the same way.
Very Important for Repeated Charging
For safety reasons, there is a built-in timer which
automatically terminates the charging cycle after 12 hours.
The batteries are then fully charged. © To re-start the
built-in timer and to start the charging cycle again, you push
the button on the charging base (press to charge) after which
the red light will start to burn and the 12 hour charging
cycle starts again.
Under normal circumstances the batteries in the Philips
Imageo Candlelights can be charged approximately five
hundred times without any loss of capacity.The capacity
will then gradually start to decline.The batteries will reach
the end of their useful life after being charged roughly a
thousand times.
Cleaning and Maintenance
Remove the adapter from the wall socket.The adapter (A)
and charger (B) can then be cleaned wth a dry cloth.The
Philips Imageo Candlelights (C) can also be cleaned with a
damp cloth. Do not use cleaning agents! The Candlelights
should not be placed in the dishwasher.
0
0
0
0
Do not use any other adapter than the one that
is supplied.
Do not submerge the individual parts in water.
Do not use perfumed liquids.
Do not expose the products to extreme heat.