Cary Audio Design CAD 211 FE - Manual (Page 7)

FEATURES
Top Panel
......................................................................................................................................................
OFF-ON TOGGLE SWITCH
Turns AC power on in the rear position
The output tube will not light at this point
......................................................................................................................................................
STANDBY SWITCH
Turns the filament of the output tube on in the rear position
......................................................................................................................................................
Rear Apron Features
......................................................................................................................................................
INPUT
Signal input connection via shielded RCA interconnect cable or
balanced input via XLR (pin 1= GND, pin 2 +, pin 3 -)
......................................................................................................................................................
OUTPUT Three 5-way binding posts provide output to the speaker
system (4, 8 or 16 ohm connections)
......................................................................................................................................................
FUSE AC power fuse. Never replace with any other value than
4 AMP SLOW BLOW FUSE! 250 VOLT!
......................................................................................................................................................
TUBE FUSE
Never replace with any other fuse than 1/2 amp FAST BLOW
FUSE!
......................................................................................................................................................
6