Philips AQ6548/01Z - Manual (Page 6)

Radio
SUPPLY
Batteries
• Insert as indicated two alkaline batteries, type R6, UM3 or AA.
• Remove the batteries if they are exhausted or if they are not to be
used for a long time.
Mains adaptor
• Connect a mains adaptor to the 3V DC socket.
• The adaptor must supply 3V DC ©-€>-©, minuspole © to the 1.3 mm
centre pin of the 3.4 mm socket.
Remarks: When you use the set for the first time or when you have
left the set without batteries for a long time, the display may show in­
correct information, or the preset stations may not be received correct­
ly. If this is the case, pressing a ballpoint pen through the hole in the
back of the set enables you to reset the display and to re-programme
the preset stations.
Sometimes, the preset stations have to be re-programmed after chang­
ing the batteries.
RADIO RECEPTION _________________ _________ _
9/10 kHz switch for AM (= MW)
Important: You must set 9/10 KHz switch to correct position before use:
• 10 kHz - for use in North and South America.
• 9 kHz - for use in all other countries.
• Set RADIO/TAPE to RADIO.
• Connect headphones to 0. The headphone lead will function as FM-aerial.
• Select the wave band using FM»AM. The display shows 'FM' or 'AM'.
• In case of FM, set FM ST/FM (mono) to the desired position.