Care and cleaning, Defrosting the fridge, Changing the light bulb – CDA FW222 User Manual
Page 5
Care and cleaning
Always disconnect the appliance from the power supply before any cleaning or maintenance.
The fridge sections should be cleaned using a solution of bicarbonate of soda and lukewarm water. Do not use abrasive
products or detergents. After washing, rinse and dry thoroughly.
Clean the shelves and balconies separately by hand with soap and water. Do not put them in the dishwasher.
The water drain hole at the back of the fridge compartment and the evaporating tray should be clened periodically to
prevent the defrosted water from collecting inside the fridge compartment. The drain plug can be used to clean the
drain hole.
Once cleaning is complete, then reconnect the power.
•
Keep the door gasket clean. If damaged, the gasket should be replaced.
•
If the appliance is not used for prolonged periods of time, unplug and clean the appliance. The door should be left
slightly open to prevent the formation of mildew and smell.
Defrosting the fridge
The fridge is self-defrosting. Any water created will run out of the fridge through the channel at the back of the fridge.
It is important to keep the channel clear at all times. The defrosted water is collected in the evaporating tray at the back of
the appliance.
Changing the light bulb
Disconnect the appliance from the power.
•
Carefully remove the light cover by pushing in the lever at the back of the cover, and then pulling the cover down..
•
Unscrew the light bulb to remove it and replace with a new bulb (not more than 15W).
•
Replace the light cover and reconnect the power after five minutes’ delay as explained on page 3.
fig. 1
FW222 Fridge Freezer Manual.indd 5
11/02/2011 16:38