Philips AZ 1011 - Manual (Page 15)

Troubleshooting
If a fault occurs, first check the points listed below
before taking the set for repair. Do not open the
set as there is a risk of electric shock.
If you are unable to remedy a problem by following
these hints, consuit your deaier or service center.
WARNING; Under no circumstances should you try
to repair the set yourself, as this will invalidate the
warranty.
Problem Solution
No sound -Adjust the VOLUME
Power cord not securely
connected
- Connect AC power cord properly
Batteries dead /incorrectly
inserted
- Insert (fresh) batteries correctly
Display does not function
properly/ No reaction to
operation of any of the
controls
- Electrostatic discharge
- Switch off and unplug the set. Reconnect after a few
seconds.
Er indication - No CD inserted, insert a CD
CD badly scratched or dirty - Replace/ clean CD, see Maintenance
Laser lens steamed up -Wait until lens has cleared
-Wait until lens has acclimatized
CD-(R) is blank or the disc
is not finalized
- Use a finalized CD-(R)
CD playback does not work - CD badly scratched/ dirty Replace/ clean CD (see
maintenance)
The CD skips tracks - CD damaged or dirty. Replace or clean CD.
- Program is active. Quit program mode
Poor cassette sound quality - Dust and dirt on the heads, etc.
Clean deck parts, see maintenance.
- Use of incompatible cassette types (METAL or
CHROME). Only use NORMAL (lEC 1) for recording
Recording does not work - Cassette tab(s) may be broken. Apply a piece of
adhesive tape over the missing tab space.
IS