Philips AJ 3250/05W - Manual (Page 5)

Installation Radio / Clock
BUTTOIMS RADIO
( 1 )
(
2
)
(3;
(5)
( 6 )
(7)
i8)
(3]
(10'
(11)
12)
il3'
i14'
)15'
116'
(17J
(18'
TIME - to set time
ALARM switch 1
OFF - alarm is switched off
RAD(io) - to wake by radio at alarm time 1
BUZ(zer) - To wake by buzzer at alarm time 1
ALARM switch 2
OFF - alarm is switched off
RAD(io) - to wake by radio at alarm time 2
BUZ(zer) - To wake by buzzer at alarm time 2
RADIO switch:
ON - radio is switched on
OFF - radio is switched off
FAST UP - fast forward ±
SLOW DOWN - slow backward ^
ALARM 1 ■ to set alarm 1
ALARM 2: to set alarm 2
BATTERY COMPARTMENT
SLUMBER - to slumber/set slumber time
ALARM RESET - to switch off the alarm for
24 hours
DISPLAY
REPEAT ALARM/SLUMBER OFF switch:
to sv^iitch off alarm temporarily
to switch off slumber function
VOLUME - to adjust sound level
TUNING - for station selection
BAND - for v;aveband selection
ACMAINS
VOLTAGE selector (not on all versions)
MAINS CONNECTION
• Check if the mains voltage as shown on the
type plate on the base of the set corresponds
to your local mams supply.
If It does not. consult your dealer or service
orgariisation.
- If the set is equiped with a VOLTAGE selector,
set this selector to the local mains voltage.
• As soon as you insert the mains plug into the
wall socket, the figures on the display @ will
blink. This means that you must set the correct
time.
• To disconnect the set from the mains comple­
tely. withdraw the mains plug from the wall
socket.
Important note for users in the U.K.
When fitting a mams plug, follow the instructions
on page 4.
Switching on the radio
• Set the RADIO switch 0 to ON. The radio will
now come on.
• Select the waveband with the BAND switch
• Select the required station with the TUNING
knob ii|i.
• Adjust the sound level with the VOLUME
control (g).
Switching off the radio
• Set the RADIO switch © to OFF.
Aerials
- The AM aerial is built into the appliance. You
may have to adjust the position of the clock
radio slightly for better reception.
“ For FM reception, there is an aerial wire at the
rear of the ciock radio. This wire must be
extended and, if necessary adj'usted slightiy, in
order to obtain good reception.
CLOCK__________________________________
Clock display
- The clock display @ shows the time and
indicates whether you have switched on the
alarm.
Setting the time
• Keep the TIME button © pressed and set the
correct time as follows:
- Fast forward with the FAST UP ±. button ®.
- Slow backward with the SLOW DOWN
button 0.
• Release the TIME button ® The correct time
appears in the display.