ISP Technologies BETA BASS - Manual (Page 6)

SETTING THE DECIMATOR THRESHOLD
Start by setting the Threshold for minimum, full
counterclockwise. Turn the Threshold control clockwise
until the desired effect of the downward expander is
achieved. The expander should start to operate when
there are gaps in the audio or as the input signal gets
close to the noise floor. NOTE: Setting this control to
high will cause the expander to start to cut off the input
signal to soon.
SPECIFICATIONS
Input Impedance
Maximum Input Level
Maximum Output Level
Bass Treble Cut Boost Level
Low/Mid parametric frequency
range
High/Mid parametric frequency
range
Compression Section
Decimator Noise Reduction
Power Requirements
Current Draw
Dimensions
500K ohms
+20dbu typical
+20dbu typical
+/- 15db
60Hz-1kHz
200Hz-6kHz
Based on Time Vector Processing
adaptive response auto makeup
gain
Greater than 80db
9V AC 1000ma
865mA
19” x 6” x 1¾”