Craftsman 509398 - Manual (Page 20)

20
16. Move the arbor shaft over the lowest
point.
17. Place the handle end of the arbor
wrench over this point and lower the arm
until the arbor shaft is just touching the
wrench. The wrench should slide back and
forth with slight contact.
18. Move the arbor shaft over another point.
Do not change the elevation of the arm.
19. Tighten the mounting screws and/or lev-
eling screws until the handle of the arbor
wrench just fits between this point and the
arbor shaft. The wrench should slide back
and forth with slight contact. Use a 1/8 inch
hex “L” wrench to tighten the leveling screws.
20. Repeat steps 18-19 for the last two
points.
Making Front Table Flat
1. Lay the edge of the rear table across the
front edge of the front table. There should be
no gaps between the two.
2. If you see a gap larger than 1/32 inch,
tighten the center mounting screw and/or the
leveling screws until the gap is gone. Use a
1/8 inch hex “L” wrench to tighten the level-
ing screws.
3. Repeat steps 1-2 at the rear edge of the
front table.
Assembly