Instrument panel – HONDA 2004 CR-V - Owner's Manual User Manual
Page 62
On Canadian models, this indicator
comes on with reduced brightness
when the Daytime Running Lights
(DRL) are on (see page
).
This comes on with the high beam
headlights. See page
for
information on the headlight
controls.
This comes on as a reminder that
you must refuel soon.
The left or right turn signal indicator
blinks when you signal a lane change
or turn. If the indicator does not
blink or blinks rapidly, it usually
means one of the turn signal bulbs is
burned out (see page
). Replace
the bulb as soon as possible, since
other drivers cannot see that you are
signaling.
When you turn on the Hazard
Warning switch, both turn signal
indicators blink. All turn signals on
the outside of the vehicle should
flash.
This indicator comes on when you
turn the ignition switch to ON (II)
with the headlight switch off and the
parking brake set. It should go off if
you turn on the headlights or release
the parking brake. If it comes on at
any other time, it means there is a
problem with the DRL. There may
also be a problem with the high
beam headlights.
This comes on when you set the
cruise control. See page
for
information on operating the cruise
control.
Canadian models only
Instruments and Controls
Instrument Panel
Turn Signal and Hazard Warning
Indicators
‘‘Daytime Running
Lights’’ Indicator
High Beam Indicator
Low Fuel Indicator
Cruise Control Indicator
58
Main Menu
Table of Contents